Search

You searched for “ltc3300”
Filters
Filters
Tools and Models
- 43
- 1
Site Section
- 355
- 4
Results on Analog.com
Relevance
Sort by
- LTC3300-2Recommended for new designsProductBattery Cell BalancersAddressable High Efficiency Bidirectional Multicell Battery Balancer
- LTC3300-1Recommended for new designsProductBattery Cell BalancersHigh Efficiency Bidirectional Multicell Battery Balancer
- LTspiceLTspice® is a powerful, fast and free simulation software, schematic capture and waveform viewer with enhancements and models for improving the simulation of analog circuits.
ASC
- VideoSep 18, 2017Active balancing of series connected battery stacks exists for many common battery chemistries, but up until now not for lead acid. Skepticism abounds as to the need and benefit of active balancing for lead acid batteries but this skepticism is misplaced. As this video will show, series-connected lead acid batteries do require balancing and the LTC3305 is the best solution for both extending battery life and increasing run-time performance.Balancing lower voltage chemistries …
- Technical ArticlesAug 18, 2016With passive and active cell balancing, each cell in the battery stack is monitored to maintain a healthy battery state of charge (SoC). This extends battery cycle life and provides an added layer of protection by preventing damage to a battery cell due to deep discharging over overcharging. Passive balancing results in all battery cells having a similar SoC by simply dissipating excess charge in a bleed resistor; it does not however, extend system run …
- VideoOct 17, 20182:08The LTC3300 & LTC6804 demonstration circuit is used to simulate the active balancing of 12 Li-Ion cells. This is achieved by using a Capacitor board consisting of 72 supercapacitor locations to simulate 12 Li-Ion cells.
- Evaluation Board & KitThis evaluation board is obsolete and no longer recommended. The replacement board is the DC2100B-C. DC2064A Demo Board for: LTC3300-1 High Efficiency Bidirectional Multicell Battery Balancer LTC6803-2 and -4 Multicell Battery Stack Monitor
- Evaluation Board & KitThis evaluation board is obsolete and no longer recommended. The replacement board is the DC2100B-C. Demonstration Circuit DC2100A-C is a stand-alone Active Cell Balancer for balancing up to 12 Li-Ion cells; it also is the master controller board when used with DC2100B-D slave boards for a stackable battery balancing solution. It consists of the LTC6804-2 Multicell Addressable Battery Stack Monitor and two LTC3300-1 Active Cell Balancers. It contains …